Do you listen when your equipment speaks to you?

Tor Idhammar Michael Lippig
Tags: maintenance and reliability

Do you listen to your motors complaining about overload? Do you see your pump packings crying a flood? Do you hear your bearings whine about contaminated lubricants? Do you notice your steam system coughing excessive condensate and complaining about strained elbows?

 

There are two types of people in mills. There are people who notice when equipment show signs of distress, and people who don’t. We often call people who don’t see the signs of distress in equipment “mill blind” people. The mill blindness may not be intentional, but rather a product of being so used to the environment that poor equipment condition just isn’t noticed. Let us supply you with a small informal mill blindness test.

Below are a few examples of mill blindness that we often see in pulp and paper mills. Most of you have at some point seen these equipment problems before, but ask yourself, are we accepting these conditions or are the problems corrected in our mill?

 

Basic condition monitoring
Leaking rotary joints are so common in many mills that they have become accepted over the years. It’s not unusual for new employees in a paper machine area to be told that leaking rotary joints are normal, and that leaks can’t be detected before steam is coming out of the joint.

 

Steam joints often leak when the carbon ring wears inside the joint. The carbon ring is designed to wear and start to leak after wearing a certain amount. The wear in most joint designs can easily be measured since the carbon ring is spring-loaded and two surfaces of the joint moves as the carbon ring wears. For example, a certain Valmet model requires carbon ring change when the distance – (a) in Figure 1 – wears to 0.59 inches (15 millimeters). Many Johnson joints have a pin to indicate the amount of wear on the carbon ring.

 

 

Figure 1. Valmet steam joint.

 

Stored Items
Spare parts storage can have a huge impact on the level of planning and scheduling of maintenance jobs and the reliability of equipment. But, we often forget the direct reliability impact of incorrect management of spare parts.

 

Some spares are perishable goods, mostly components with rubber or plastic material such as belts, couplings and O-rings. For example, the commonly used orange peel coupling has a “best before date” when purchased. They are designed to last five to six years whether in use or stored in the store room. It is common to find couplings five years and older in stores even though their life already is exceeded.

 

Bearings should be wrapped and sealed in order to avoid contaminants in the bearing. It’s not uncommon to find bearings unwrapped and dusty in a store room.

 

Mill sites often have a small vibration in the store room from surrounding equipment. When bearings are fixed in the same position, the vibration causes fatigue damage inside the bearings, because the bearing balls keep “tapping” the outer bearing race. Shafts on stored motors should therefore be turned a quarter turn on a periodical interval to reduce the damage. Take a look in your storeroom. Are motor shafts of motors turned by storeroom personnel?

 

 

 

 

Figure 2. Top, bearing stored without protective wrapping. Bottom an “orange peel” coupling with manufacturing quarter and year on the sticker to indicate perishable date.

 

About the authors:

TorbjornIdhammar is the vice president and Michael Lippig the business development manager of IDCONInc., a Raleigh, N.C.-based reliability and maintenance managementconsulting firm which specializes in education, training and implementation of improved operations, reliability and maintenance managementpractices. To learn more, visit www.idcon.comor e-mail info@idcon.com.

 


About the Author
About the Author